View Single Post
  #38 (permalink)  
Old 03-23-2013, 05:56 PM
Liphookedau's Avatar
Liphookedau Liphookedau is offline
Senior Member
 
Join Date: Jul 2008
Location: AUSTRALIA
Posts: 2,794
Liphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud of
Default Re: Rotary Vise Suggestions

I like my Atlas it works quite well however The Machining is a Little Rough on a few Parts.
I also made a couple of mods :
1 I drilled a hole in The Top Part of The Handle so it could be Tightened.
2 I put a Washer & an O Ring between The two End Knurled Parts to Prevent them from Locking Up.
Brian.
Reply With Quote