View Single Post
  #14 (permalink)  
Old 04-15-2013, 08:43 PM
Liphookedau's Avatar
Liphookedau Liphookedau is offline
Senior Member
 
Join Date: Jul 2008
Location: AUSTRALIA
Posts: 2,786
Liphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud ofLiphookedau has much to be proud of
Default Re: Welded Perfection Loop Breaking?

Even though I haven't had it happen yet people I've Fished with have.
I was going to Post A reply here which after a few interruptions I Posted in The Wrong Place,everything I was going to mention has been covered.
Most of it is also Covered on You-Tube which is a good place to look.

Fred.
I always find it hard as I use heat Shrink Regularly & I find the best way is to either do a Trial Run or Keep Adding or Removing The Heat as I mainly use either a Heat Gun or a Cigarette Lighter.
In The Video I watched They advised to do a Trial Run on an Old Piece of Line.
Brian
Reply With Quote