Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. Default How to replace a cheap handle & Butt?

    Where can you recommend I go to pick out a better quality handle & butt?

    How do I remove a handle & butt?

    I have about 3 weeks before a big trip of a week's fishing.
    I'd like to improve what I have.

    Thanks guys.
    Welcome to the world of Fly Crying

  2. #2
    Join Date
    Aug 2010
    Location
    On a trout stream/Suburban Pittsburgh
    Posts
    3,358
    Blog Entries
    1

    Default Re: How to replace a cheap handle & Butt?

    I did this once on an old Browning fly rod. I am not a rod builder and it wasn't too bad.

    To remove the old one, I used an old pot and stuck the cork and butt in the boiling water for a few minutes. That loosened the epoxy enough to allow me to remove it.

    I ordered cork and a reel seat from JStockard but there are lots of options out there. Mudhole, Hook & Hackle have rod building supplies. I'm sure some of the builders can give you other ideas. You might want to pick up a reamer to allow you to get the cork the right diameter for the blank to fit into.

    I used 30 minute epoxy if I remember right.
    ~*~Leave only your footprints~*~

  3. #3
    Join Date
    Jan 2013
    Location
    Central Coast of Calif
    Posts
    321

    Default Re: How to replace a cheap handle & Butt?

    The boiling water will work on the seat. If you are saving the seat stick it inside a couple of plastic bags. Boiling water and seat finishes don't mix too well. Once the epoxy softens, don't twist when you remove the seat. Easy way to splinter the blank.

    As for the handle. There is no way to save the cork, so you can kind of grind it off with some pliers. Once the majority of removed, you can shave it off with a razor blade. Then heating the old epoxy with a hair dryer can help you scrape off the remaining epoxy easier.

    When you ream the new handle don't make it too loose. Just go snug, but not too tight. Too tight and you will squeegy off the epoxy and the handle may eventually work loose.

    Good luck,

    Pete
    "Blessed is the fly fisher who's quiver contains grass, glass & graphite custom rods." Book of Rods 3:16

Similar Threads

  1. how often do you replace lines?
    By TexUte Fly in forum General Discussion
    Replies: 5
    Last Post: 05-06-2012, 07:02 AM
  2. G Loomis Metolius Replace with East Fork
    By indymatt in forum Fly Rods
    Replies: 8
    Last Post: 08-26-2011, 01:14 PM
  3. How much $ to replace a Cork handle?
    By ausablebrown in forum General Discussion
    Replies: 37
    Last Post: 02-17-2011, 10:13 AM
  4. Replace reel seat and cork?
    By trout champ in forum General Discussion
    Replies: 7
    Last Post: 04-25-2008, 09:03 PM
  5. Fly Rod Choices to replace one broken ?
    By tie one on in forum General Discussion
    Replies: 3
    Last Post: 06-27-2007, 07:48 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •