The North American Fly Fishing Forum

The North American Fly Fishing Forum (
-   General Discussion (
-   -   Ferrule repair (

jwhuntman 03-21-2013 08:55 PM

Ferrule repair
Hello guy's, I'm new her and need some advice. I received a H-I bamboo Spinner 9' rod in trade. I like the rod but the bottom ferrule will move about 1/8" when taking the 2nd piece out. Any ideals on how to tighten it up? Would you totally remove it and glue or what? HELP!!!

Guest1 03-21-2013 09:27 PM

Re: Ferrule repair
I'd remove it, clean everything and 5 minute epoxy it back into place. Put the epoxy on the inside of the ferrule all over. Use enough to get it glued well and have a rag and alcohol standing by for clean up. you may want to put a band of masking tape around the rod where the end of the ferrule hits the cane. Use a type that is not very sticky so you don't pull varnish off.

All times are GMT -5. The time now is 07:21 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimisation provided by DragonByte SEO v2.0.40 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
2005-2017 The North American Fly Fishing Forum. All rights reserved.