Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Help with casting

  1. Default Help with casting

    Alright , so now I have 2 questions :

    1- I don't have a tippet (I just have backline, fly line, leader, fly) is that bad? Should I buy a tippet? Are they expencive?

    2- I was training my casting without a fly, just the line and i heard a noise when i was casting. It was the line hitting itself and I broke a little piece.
    Is that because I didn't have a fly or because I'm a bad caster? (I just started fly fishing )

  2. Default

    Yes buy some tippet i sugest a spool of 5x and a spool of 6x,the snap you hear when casting without a fly is the leader,try snapping off a fly at the bend in the hook,or tie a small peice of yarn on your leader to practice casting with.learn the proper knots to attatch tippet to your leader and your in buisness
    tight lines
    Aaron

  3. Default

    1. No... you don't need a tippet to learn how to cast. The main reason for the tippet is to lengthen your leader or to drop it down one size. For now, don't worry about tippet.

    2. The cracking sound you're hearing is probably a result of two things. 1) If you don't have a fly you will often times here this. 2) The major reason is likely because you're starting your forward cast too soon. After your back cast, you must wait until the line gets fairly strait out behind you before you begin your forward cast... otherwise, you're cracking the whip. This is one of the most common mistakes made by new casters. So, pause before you go forward. Also... you can reduce the crack if you will tie a one inch section of yarn to the end of your leader. This will act as the fly.

    For the beginner, the fly cast requires you to concentrate on so many things at the same time. There are many different techniques use to teach the fly cast... most are good... some are ****.

    Remember these important factors.

    1. Don't bend your wrist (bend your elbow)
    2. On your backcast, pull the rod up slowly, gradually increasing speed.
    3. Power Stroke - At the end of your backcast, you must have a short (few inches) burst of power, flicking it, but don't bend your wrist too much.
    4. You must stop your rod at the 12:00 position. Do not go too far back.
    5. Wait - Before you begin your forward stroke you must pause for the line to straighten behind you. You can look over your shoulder and watch it for a while if you want.

    Eventually, all of this will become second nature to you.

    Work on those factors for a while and then report back to us.

    Steve

Similar Threads

  1. One question about flies
    By pedrim17 in forum Flies
    Replies: 2
    Last Post: 07-07-2006, 11:16 PM
  2. Hawaii Tukes on the Fly
    By Stan Wright in forum Pacific Ocean
    Replies: 1
    Last Post: 06-25-2006, 08:47 AM
  3. reel for sage 8ds2
    By ffffg in forum Pacific Northwest
    Replies: 1
    Last Post: 04-10-2006, 12:53 PM
  4. Welcome, ERICL!
    By Fish Bones in forum Member Introductions
    Replies: 2
    Last Post: 10-03-2005, 09:11 AM
  5. Welcome, lvs2fsh!
    By Fish Bones in forum Member Introductions
    Replies: 0
    Last Post: 05-16-2005, 06:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •